I really don’t know whats happening. Especially with the Over and Underextruding… Heck the Bottom Left pic shows both happening basically right next to eachother… whats going on?

(The Printed Model in the pic is just the Entire First layer and buildplate printed in. Letting it Run a Third time now to see if the Patterns stay the same)

  • rugburn@lemmynsfw.comEnglish
    2·
    10 hours ago

    I had this happen on my p1s with a roll of Inland pla, but not with a roll of their pla +, I also noticed my nozzle was worn (who knew that after 850 hours you should probably replace it). Haven’t gone back to the normal pla yet, but those might be things to look at?