I am using an Ender 3 Pro v2, and I have followed multiple guides (they all say the same things) for setting up a print to prevent stringing. I’ve also switched between two filaments (Creality and Amolen) and the stringing doesn’t change at all. I have noticed that when heating up the horned, the filament just oozes out like ectoplasm even before the print starts.

I have never had this problem before, and could use some human advice.

I have upgraded/replaced the following parts in the past:

  1. Bowden Tubes
  2. Printer Nozzles
  3. Dual Gear Extruder
  4. Heater Block
  5. Heater Cartridge
  6. Thermistor Temp Sensor

My Tweaked Settings:

    • dohpaz42@lemmy.worldOPEnglish
      3·
      5 days ago

      Since my oven can only go as low as 75°C, I ordered a filament dryer. 😠

      ~Stupid oven.~

      • tonyn@lemmy.ml
        3·
        5 days ago

        Anytime I take a spool off the printer I put it back in the filament dryer. Once it’s done it goes in a sealed bag with dessicant. This keeps the filament dry and prevents stringing.

        Also don’t use your food oven for plastic anyway.

        • dohpaz42@lemmy.worldOPEnglish
          1·
          5 days ago

          Anytime I take a spool off the printer I put it back in the filament dryer. Once it’s done it goes in a sealed bag with dessicant. This keeps the filament dry and prevents stringing.

          Would a plain old ziplock bag with the air vacuumed out be sufficient?

          Also don’t use your food oven for plastic anyway.

          😅 um… 😅 🥺